« back

·

close window

 
Configure Phone Lines

1. Enter the line access code followed by the letter "T" (wait for dial tone) in the upper box labeled Prefix (example below dials '9T' for an outside line)
2. If you need to dial a line access code for long distance numbers (even if it is the same as your local line access code) enter it in the lower Prefix box.
3. Repeat steps C & D for each line (port) you have purchased, by selecting each installed line in turn that is active the "Select Lines" column.
4. Click the OK button at the bottom left of the screen when you are done.

If your PhoneTree® is correctly installed and recognized, the line cards will be displayed on this screen as a simple number, i.e. 2. Anytime you see a number shown between two hyphens, that means the PhoneTree® line card is NOT recognized by Windows® , i.e. -2-. Also, when a correctly installed number is highlighted in the list, you will see the green dot at the top with the word "Detected" next to it (as shown in the picture above).